Industrial Machinery

KraussMaffei Extrusion Offers Single-Stage PVC InlineMixing Process for Roofing Membranes

The continuous route replaces separate hot-cold mixing and dryblend storage, with the company citing up to 75% lower energy consumption plus lower capital and operating costs.

Ingrid SolheimNovember 17, 20265 min read0 views

Concept illustration of a continuous PVC membrane line in which dosing units feed a twin-screw extruder and calender rolls form the sheet into a finished roll.

KraussMaffei Extrusion has introduced a single-stage extrusion process for PVC roofing membranes that folds compounding into the continuous extrusion line. Presented from Laatzen on November 17, 2026, PVC InlineMixing is offered as an alternative to the two-stage route in which raw materials are first blended in a separate hot-cold mixer. The company says the continuous approach lowers energy costs, shortens production time and supports a fast return on investment.

In the conventional sequence, PVC powder, plasticizers, additives and fillers are processed batchwise into a dryblend inside a hot-cold mixing combination. That blend is cooled, stored intermediately and only then plasticized in a twin-screw extruder and formed into membrane. PVC InlineMixing removes those steps: all solid and liquid components are metered directly into the extruder by gravimetric dosing systems, in the quantities the formulation calls for.

Lower energy demand and a smaller footprint

Because the material is heated only once and no separate heating-cooling mixer is required, the company reports that energy consumption and energy costs fall by up to 75%, depending on the formulation, the system parameters and the site. The claimed benefits extend beyond electricity:

  • No investment in a separate heating-cooling-mixing combination;
  • Less floor space for the overall system;
  • Lower labor costs, since dryblend premixing and its handling are no longer needed;
  • Lower maintenance, because wear parts for the hot-cold mixer are no longer consumed.

Lower capital expenditure and lower operating costs together are said to improve overall cost-effectiveness and create the conditions for a quick payback. These are the supplier's projections rather than independently measured figures.

Formulation changes during operation

Removing dryblend batches also changes how recipes are handled. Adjustments to formulations and color changes can be made directly during operation through the integrated control system, which eliminates the time-consuming preparation and intermediate storage of separate batches.

Christopher Bartel, Head of Sales Flat & Foam at KraussMaffei Extrusion, frames this as a competitive advantage for membrane manufacturers: lower production costs, greater flexibility and more efficient manufacturing, with the ability to react faster to new requirements, adjust formulations during the running process and reduce both energy and capital expenditure.

Tested with industrial roofing formulations

The process was developed at the KraussMaffei Extrusion Technology Center in Laatzen and validated with industrial roofing membrane formulations. The trials used a co-rotating twin-screw extruder from the ZE 65 BluePower series, equipped with loss-in-weight feeders for all solid components and several liquid feeders for free-flowing ingredients. The series has a Da/Di ratio of 1.65; the combination of high torque and large free volume is intended to provide a wide process window for different recipes.

Testing confirmed high gelation levels of the PVC and what the company describes as high product quality. Mechanical properties and weldability of the membranes met industrial requirements across several formulations. Bartel says the results demonstrate the potential of PVC InlineMixing for industrial membrane production, and that customers can test their own formulations under production-relevant conditions at the Technology Center to optimize the process and prepare for implementation.

Already running in production

One industrial line already uses the process. The reference plant reaches a total throughput of 1,800 kg/h with two extruders and two calenders, processing PVC, additives and fillers together with the resulting edge trimmings continuously into finished membrane.

The significance for roofing membrane producers lies less in a single machine than in the elimination of a discrete processing stage, with the resulting changes in energy use, staffing, space and batch handling.