Automotive Accessories

Builder Flips Jeep Rear Diff Upside Down for a Budget Portal Axle

Zeph Gage combines a Ford 9-inch housing with Humvee geared hubs and adapters to gain roughly six inches of rear clearance at about a fifth of a typical portal axle's price.

Astrid BerglundNovember 17, 20265 min read1 views

A cutaway-style illustration of a rear axle with its differential mounted upside down and a geared hub inside a tall off-road tire, set on a workshop floor.

Portal axles are valued by hardcore off-roaders because they lift a vehicle's drivetrain hardware well above the ground, but a commercial set can run around $20,000. A build by Zeph Gage, documented in a video from Outdoor Auto, takes a different route: a rear-only portal assembled from production parts for roughly a fifth of that figure.

A portal axle places a stack of gears behind each driven wheel instead of letting shafts and differential hardware hang below the frame. That layout allows the axle tubes to sit much higher, and combined with tall tires it produces ground clearance a conventional solid-axle drivetrain cannot match. The trade-off is cost and complexity, which is where the Gage build departs from the norm.

How the conversion works

The parts list mixes components from other vehicles: a Ford 9-inch axle housing, geared hubs from a Humvee, and a set of Jesse Haines Fabrication HMMWV portal adapters.

Two-gear portals like the Humvee units reverse the direction of the input shaft's rotation. To correct for that with the Ford 9-inch, Gage mounted the differential upside down so the driveline spins the correct way. A Yukon Gear and Axle third member is then bolted to the flipped differential, which in effect turns low-pinion parts into a high-pinion unit.

According to the report, the arrangement adds about six inches of clearance, retains full shock travel — something described as tricky to achieve with portal axles — and reduces stress on the differential itself, which is expected to make it effectively bulletproof.

Why only the rear axle

Gage installed the portal at the rear only. Keeping the solid axle up front avoids the packaging constraints that typically appear when portal axles are fitted to a vehicle that never had them from the factory. It also means shock travel does not have to be restricted to make room, and ride height is not raised to an extreme level. The article notes that the same rear-only approach is a common trick in the radio-controlled rock crawler scene.

Custom fabrication and brakes

The conversion is not a bolt-on kit. Gage did substantial custom work, including homemade brackets and custom-tapped plates, plus a two-piece brake rotor paired with a Ford Fusion caliper. He chose the Fusion hardware partly because it offers an integrated electric parking brake solenoid and partly for clearance reasons.

The result is an XJ Jeep that, per the report, can drive over a five-gallon bucket and still have several inches of clearance to spare. In practice, the rear end is less likely to hang up on obstacles that the front end can simply steer around. The article characterizes the setup as an ingenious piece of kit that required considerable thought to get right, and concludes the effort was worthwhile. Gage covers further specifics, including how he matched gearing front and rear, in the Outdoor Auto video.